![]() Role out the copper coil and slowly start to bend it around the outside diameter of the stove. ![]() You will need the same copper coil as option 1 for this method. You can also keep the copper tubing outside the barrel stove which makes installation a bit easier. The disadvantage is that after a couple of years the coil gets build up of creosote and needs to be taken out and cleaned. This method, in my opinion, is the better option because you get the tubing right in the hottest part of the fire. As you push it up into place feed the open ends of the tubing through the holes you drilled in the back of the barrel so they stick out about 1"-2". Carefully insert the coil inside the barrel and on top of the thread rods. Once the threaded rods are in place you need to straighten about 12" of tubing on each of the ends pointed toward the back of the barrel. You will need a type L 20' (or more if you want) 1/2" copper coil for this project. This will make a kind of shelf for the copper coil.ĭuring this step I also drilled two holes in the back of the barrel to accommodate the 1/2 copper tubing. I then inserted 24" threaded rod through the barrel and secured using 3/8 washers and nuts. As you can see in the picture I drilled the holes about 8" apart and close to the top of the barrel. I started by drilling holes to fit a 3/8" threaded rod. We need to get a coil of copper tubing inside the barrel for this option. There are two different ways to go about this step and I will show you both (since I have tried both) and let you chose how you want yours to look and work.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |